Documents & Publications

This page contains documentations, publications and presentations produced in the scope of this project. The presentations are available in pdf format. The publications are in most cases copyright protected and a link is provided to the publishing journal or magazine.

 

Project publications

The project publications are available for registered users only. In order to download below documents, you are required to be registered.

 

Publications Angle Metrology project

Position Reports describing the current state of the art in Angle Metrology  

 

Peer Reviewed

  1. Geckeler RD, Link A, Krause M, and Elster C
    Capabilities and limitations of the self-calibration of angle encoders
  2. Meas. Sci. Technol. 25 (2014) 055003 10pp
  3. Youichi Bitou and Yohan Kondo, “High-lateral-resolution scanning deflectometric profiler using a commercially available autocollimator”, Meas. Sci. Technol. 24 July 2014, Vol. 25, 095202 (6pp)
  4. F. Siewert, J. Buchheim, T. Zeschke, M. Störmer, G. Falkenberg, R. Sankari, “On the Characterization of ultra-precise X-ray optical components – advances and challenges in ex-situ metrology” , J Synchrotron Radiat. Sep 1, 2014; 21(Pt 5): 968–975.Invited paper at Journal of Synchrotron Radiation, Special Issue on Diffraction Limited Storage Rings and New Science Opportunities Published online Aug 27, 2014. doi: 10.1107/S1600577514016221
  5. Geckeler RD and Just A 2014, “A shearing-based method for the simultaneous calibration of angle measuring devices”, Meas. Sci. Technol.25 105009 15pp
  6. S. Roling, H. Zacharias, L. Samoylova, H. Sinn, Th. Tschentscher, O. Chubar, A. Buzmakov, E. Schneidmiller, M. V. Yurkov, F. Siewert, S. Braun, P. Gawlitza, “Time-dependent wave front propagation simulation of a hard x-ray split-and-delay unit:”, PHYSICAL REVIEW SPECIAL TOPICS - ACCELERATORS AND BEAMS, 17, 110705 (2014) DOI:10.1103 /PhysRevSTAB.17.110705
  7. Ralf D. Geckeler, Michael Krause, Andreas Just, Oliver Kranz, and Harald Bosse, “New frontiers in angle metrology at the PTB”, , Measurement, 73 231–238 (DOI:10.1016/j.measurement.2015.05.010)
  8. Oliver Kranz, Ralf D. Geckeler, Andreas Just, Michael Krause, Wolfgang Osten, “From plane to spatial angles: PTB's Spatial Angle Autocollimator Calibrator”, Advanced Optical Technologies DOI: 10.1515/aot-2015-0017
  9. Z. Yin, H. B. Peters, U. Hahn, M. Agåker, A. Hage, R. Reininger, F. Siewert, J. Nordgren, J. Viefhaus, and S.Techert., “A new compact soft x-ray spectrometer for resonant inelastic x-ray scattering studies at PETRA III”, Review of Scientific Instruments, 86, 093109 (2015); doi: 10.1063/1.4930968.
  10. Siarhei Dziarzhytski, Natalia Gerasimova, Rene Goderich, Tobias Mey, Ruben Reininger, Michael Rübhausen, Frank Siewert, HolgerWeigelt and Günter Brenner, “Microfocusing at the PG1 beamline at FLASH”, Journal of Synchrotron Radiation, ISSN: 1600-5775doi:10.1107/S1600577515023127
  11. R.D. Geckeler, N.A. Artemiev, S.K. Barber, A. Just, I. Lacey, O. Kranz, B. V. Smith, and V.V. Yashchuk, "Aperture alignment in autocollimator-based deflectometric profilometers", Review of Scientific Instruments, 2016 May; 87(5):051906. doi: 10.1063/1.4950734
  12. Valeriy V. Yashchuk, Nikolay A. Artemiev, Gary Centers, Arthur Chaubard, Ralf D. Geckeler, Ian Lacey, Harry Marth, Wayne R. McKinney, Tino Noll, Frank Siewert, Mathias Winter, and Thomas Zeschke, "High precision tilt stage as a key element to a universal test mirror for characterization and calibration of slope measuring instruments", Review of Scientific Instruments, 87, 051904 (2016); doi: 10.1063/1.4950729
  13. T. Yandayan, R. D. Geckeler, M. Aksulu, S. A. Akgoz, and B. Ozgur "Application of advanced shearing techniques to the calibration of autocollimators with Small Angle Generators and investigation of error sources", Review of Scientific Instruments, 87, 051903 (2016); doi: 10.1063/1.4950720
  14. F. Siewert, T. Zeschke, T. Arnold, H. Paetzelt, V. Yashchuk, "Linear chirped slope profile for spatial calibration in slope measuring deflectometry", Review of Scientific Instruments, 2016 May;87(5):051907. doi: 10.1063/1.4950737.
  15. Manuel Sanchez del Rio, Davide Bianchi, Daniele Cocco, Mark Glass, Mourad Idir, Jim Metz, Lorenzo Raimondi, Luca Rebuffi, Ruben Reininger, Xianbo Shi, Frank Siewert, Sibylle Spielmann-Jaeggi, Peter Takacs, Muriel Tomasset, Tom Tonnessen, Amparo Vivo and Valeriy Yashchuk, "DABAM: an open-source database of x-ray mirrors metrology", Journal of Synchrotron Radiation, 2016 May; 23(Pt 3):665-78. doi:10.1107/S1600577516005014.
  16. M Çelik E Þahin, T Yandayan, R Hamid, A Akgöz, B Özgür, M Çetintaþ and A Demir, "Application of Differential Fabry-Perot Interferometer (DFPI) in angle metrology", Meas. Sci. Technol. 27 (2016) 035201 (10pp), doi:10.1088/0957-0233/27/3/035201.
  17. Marco Pisani and Milena Astrua, "The new INRIM Rotating Encoder Angle Comparator (REAC)", Meas. Sci. Technol. 28 (2017), doi: 10.1088/1361-6501/aa5af6 045008.
  18. Ville Heikkinen, Ville Byman, Ilkka Palosuo, Björn Hemming and Antti Lassila, "Novel interferometric spatial angle calibration set-up for autocollimators". Submitted to Metrologia.

 

Conribution to book

  1. Frank Siewert, Optical Metrology – On the Inspection of Ultra-Precise FEL-Optics, published as a book chapter in: “Optical technologies for extreme-ultraviolet and soft X-ray coherent sources”,
  2. Springer Series in Optical Sciences, ISBN 978-3-662-47442-6, Springer Berlin Heidelberg, September 2015

 

Conference

  1. Tanfer Yandayan, Ralf D. Geckeler, Marco Pisani, Emilio Prieto and Frank Siewert, “Recent developments in angle metrology”, 2 nd MacroScale Conference, Recent Developments in Traceable Dimensional Measurements , 28th to 30th October 2014
  2. Tsukasa Watanabe, Yohan Kondo and Hiroyuki Fujimoto, “Evaluation of dynamic spindle run out ability of self-calibratable rotary encoder”, 11th IMEKO Symposium, Laser Metrology for Precision Measurement and Inspection in Industry (LMPMI), 02.-05. Sept. 2014, Tsukuba, Japan.
  3. Youichi Bitou and Yohan Kondo, “Scanning deflectometric profiler with small beam size using a commercially available autocollimator”, 11th IMEKO Symposium, Laser Metrology for Precision Measurement and Inspection in Industry (LMPMI), 02.-05. Sept. 2014, Tsukuba, Japan.
  4. Ralf D. Geckeler, Michael Krause, Andreas Just, Oliver Kranz, and Harald Bosse, “New Frontiers in Angle Metrology at the PTB”, 11th IMEKO Symposium, Laser Metrology for Precision Measurement and Inspection in Industry (LMPMI), 02.-05. Sept. 2014, Tsukuba, Japan.
  5. Tanfer Yandayan, Ralf Geckeler, and Frank Siewert, “Pushing the limits - latest developments in angle metrology for the inspection of ultra-precise synchrotron optics” Proc. SPIE 9206, Advances in Metrology for X-Ray and EUV Optics V, 92060F (September 5, 2014); doi:10.1117/12.2060953 Invited paper at SPIE 2014, Advances in Metrology for X-Ray and EUV Optics V (International) 17-21 August 2014, San Diego, California (USA)
  6. Oliver Kranz, Ralf D. Geckeler, Andreas Just, Michael Krause, “Charakterisierung und Justage des Spatial Angle Autocollimator Calibrators der PTB”, DGaO, June 2014, Karsruhe (Germany)
  7. Fernanda Saraiva, Rastreabilidade metrologica do angulo plano e a cristalografia (Metrological traceability of plane angle and crystallography), 19ª Conferência Nacional de Física | 24º Encontro Ibérico para o Ensino da Física, ISBN: 978-989-8481-45-0.”
  8. Aitor Olarra, Andoni Delgado, Mikel Zubieta, Gorka Kortaberria, Emilio Prieto, Maria del Mar Perez, Tomás Morlanes, "Development of a novel high precision Large Range Small Angle Generator", Proceedings of the 16th International Conference of the European Society for Precision Engineering and Nanotechnology, EUSPEN 2016, 30 May – 3 June 2016, Nottingham, UK. , ISBN: 9780956679086
  9. Marco Pisani and Milena Astrua, "The new INRIM rotating encoder angle comparator: REAC", Proceedings of the 16th International Conference of the European Society for Precision Engineering and Nanotechnology, EUSPEN 2016, 30 May – 3 June 2016, Nottingham, UK. ISBN: 9780956679086”

 

Master Thesis

  1. M. Castro, F. Marques, F. Saraiva, "Desenvolvimento e implementação de técnicas avançadas usando desvios com aplicação a calibrações no domínio de metrologia angular _ Error-separating shearing techniques”,
  2. RUN Repositório Universidade Nova, Master thesis report, 91 pages. September 2015